C
3
HAPTER
MOUNT THE AUTOBOOM VALVE
ADJUSTING INSTALLED AUTOBOOM VALVE
FIGURE 1. Machine's Hydraulic Valve Before AutoBoom Installation
Before
Strip this
Surface
1. Strip the factory paint from the top of the machine's hydraulic valve using a chemical approved for paint
removal.
IMPORTANT:
Do not scrape the paint from the machine's hydraulic valve. Scraping the paint may cause damage to the
valve.
2. Remove the hydraulic test port fitting and Allen plugs from the machine's hydraulic valve.
NOTE:
The test port fitting will be installed on the AutoBoom hydraulic valve later in the procedure. Protect
the test port fitting from dust and debris to avoid contamination of the hydraulic system.
3. Clean the remaining paint from the machine's hydraulic valve, taking care to prevent paint chips from entering
the open hydraulic ports.
12
Hydraulic
Test Port
Fitting
Allen
Plugs
AGCO RoGator C AutoBoom® XRT Installation Manual
After