Install The Steerable Hitch Wiring; Connect Steerable Hitch To A Raven Iso Product Control System (If Applicable); Connect Steerable Hitch To John Deere Rate Controller (If Applicable); Connect The Steerable Hitch Harness To The Valve And Sensors - Raven Unverferth NutriMax Series Installation & Operation Manual

C 3
HAPTER

INSTALL THE STEERABLE HITCH WIRING

NOTE: In addition to the steps below, refer to the system drawings at the end of this chapter for further
details.

CONNECT STEERABLE HITCH TO A RAVEN ISO PRODUCT CONTROL SYSTEM (IF APPLICABLE)

1. Locate and disconnect the machine's main power harness and the Raven ISO product control cable connection.
NOTE: The main power harness (P/N 115-7302-018) and Raven ISO product control cable (P/N 115-7302-016)
should already be installed on the applicator and are not included in the Steerable Hitch kit.
2. Install the Steerable Hitch harness (P/N 115-7302-017) between the main power harness and product control
cable connection.

CONNECT STEERABLE HITCH TO JOHN DEERE RATE CONTROLLER (IF APPLICABLE)

1. Locate and remove the existing ISO terminator from the John Deere rate control cable's 2-pin and 12-pin
connectors.
2. Install the John Deere ISO to Raven ISO adapter cable (P/N 115-7300-066) on the rate control cable.
3. Connect the Steerable Hitch harness (P/N 115-7302-017) to the John Deere ISO to Raven ISO adapter cable.
4. Install a Raven ISO terminator cable (P/N 115-7300-044) on the remaining end of the Steerable Hitch harness.

CONNECT THE STEERABLE HITCH HARNESS TO THE VALVE AND SENSORS

1. Connect the large, rectangular connectors of the Steerable Hitch harness into the correct ports of the Steerable
Hitch node (P/N 063-0173-445), tightening the bolts to secure the connections.
2. Connect the 6-pin connection on the Steerable Hitch harness to the mating connector on the applicator's
switchbox cable.
3. Connect the SPS connector on the Steerable Hitch harness cable to the rotary sensor on the king pin.
4. Route the valve connections toward the Steerable Hitch valve.
5. Connect the LEFT/OUTER connection of the Steerable Hitch harness cable to the top coil of the stack on the
Steerable Hitch valve.
6. Connect the RIGHT/INNER connection to the bottom coil of the stack on the Steerable Hitch valve.
7. Connect the remaining unlabeled cable connections to Port 1A and 1B of the Steerable Hitch valve.
8. Route the ENABLE connector to the right side folding joint and connect it to the installed proximity switch.
16 Unverferth NutriMax™ Applicator ISO Steerable Hitch Installation & Operation Manual