Install The Valve Harness - Raven SmarTrax John Deere 8R 2009 Series Installation Manual

Install the Valve Harness

Cab Floor Access Plate Removed
FIGURE 7.
Lift the floor mat just inside the door.
1.
Remove the cab floor access plate.
2.
Cut a notch (approximately 1" x 1") into the cab floor access plate.
3.
From outside the cab, route the 12-pin connector of the valve harness (P/N 115-4001-156) into the cab
4.
through the access hole in the floor.
Connect the 12-pin connector to the mating connector on the node harness (P/N 115-4001-087).
5.
Machine's Existing Steering Valve Connection
FIGURE 8.
Disconnect the machine's existing cable connection from the steering valve located in the front of the cab.
6.
Connect the VALVE connector on the valve harness to the open port of the steering valve.
7.
Manual No. 016-5034-013 Rev. B
Cab Component Installation
11