Table of Contents
Advertisement
C
6
HAPTER
FIGURE 5. Machine's Existing CAN Connection
4. Locate and disconnect the machine's existing 4-pin CAN connection in front of the transducer on the center
boom section.
NOTE:
The CAN connection may or may not have a terminator installed.
FIGURE 6. AutoBoom Harness Installed on Machine's CAN Connections
5. Install the mating 4-pin connectors of the AutoBoom harness cable on each end of the machine's CAN
connections.
NOTE:
If the machine's CAN connection had a terminator installed, install it on the remaining CAN
connection on the AutoBoom harness cable.
CONNECT THE LEFT AND RIGHT CENTERING SENSORS - IF APPLICABLE
NOTE:
The Left Prox Switch and Right Prox Switch connections on the AutoBoom cable (P/N 115-0230-073)
remain disconnected on after-market AutoBoom installations. They are connected only on machines
that have factory-installed proximity switches on the main boom fold section.
30Case IH Patriot 250/2240/2250 & New Holland SP2500 (80'-100' Booms) AutoBoom® Installation Manual
Advertisement
Table of Contents
