Table of Contents
Advertisement
6. Connect the straight end of the installed hydraulic hose to the fittings installed in Port RC of the AutoBoom
valve.
FIGURE 5. Left Cylinder Hose Installed
7. Trace the machine's left cylinder hose from the rod-end of the left tilt cylinder to the machine's hydraulic valve.
8. Disconnect the machine's left tilt cylinder hose from the machine's hydraulic valve.
9. Connect the machine's left cylinder hose to the opposite end of the tee fitting installed in the left cylinder port.
10. Install the 90° end of the supplied hydraulic hose (P/N 214-1000-494) on the 90° end of the installed tee fitting.
11. Connect the straight end of the installed hydraulic hose to the fittings installed in Port LC of the AutoBoom
valve.
INSTALL THE LEFT AND RIGHT DOWN HOSES
FIGURE 6. Left Down Hose Installed
1. Trace the machine's left return hose from the base-end of the left tilt cylinder to the machine's hydraulic valve.
2. Disconnect the machine's left tilt return hose from the machine's hydraulic valve.
3. Install a 11/16" ORFS M/F 90° swivel elbow fitting in the open port of the machine's hydraulic valve.
4. Install a 11/16" ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-069) on the installed elbow fitting.
5. Connect the machine's left return hose to the opposite end of the installed tee fitting.
P/N 016-0230-047 Rev. C
HYDRAULIC SYSTEM INSTALLATION
17
Advertisement
Table of Contents
