DGPS OUT Connected to Console Receiver Connection
FIGURE 8.
Console
Cable
Connect the DGPS OUT connector to the Viper Pro or Envizio Pro receiver connection.
6.
Install the Valve Harness
Valve Cable Routed Through Access Point
FIGURE 9.
Route the valve cable through the right-rear corner cable access grommet under the window.
1.
Connect the rectangular 12-pin connector on the valve harness (P/N 115-4001-111) into the mating
2.
connection on the node harness (P/N 115-4001-110).
Manual No. 016-5032-081 Rev. A
Cab Component Installation
Console Receiver
Connection
DGPS Out
(Node Cable
Connection)
21