C
6
HAPTER
CONNECT THE POWER LEADS
FIGURE 9. Machine's Existing Power Connection
1. Locate the machine's existing 2-pin power connection in front of the pressure transducer.
2. Remove the dust cap from the machine's power connection.
FIGURE 10. AutoBoom Harness Cable Power Connection
3. Install the Logic Power connector of the AutoBoom harness cable on the machine's power connection.
4. Connect the machine's AUX POWER connector to the AUX POWER connector on the AutoBoom harness cable.
32Case IH Patriot 250/2240/2250 & New Holland SP2500 (80'-100' Booms) AutoBoom® Installation Manual