Table of Contents
Advertisement
Road Switch
FIGURE 8.
Connect the ROAD SWITCH connector to the road switch (P/N 412-2011-104).
4.
Feed the wires back into the console.
5.
Press on the switch casing to ensure the switch is securely installed.
6.
Alternate Switch Port Installation
Note:
An alternate mounting location must be easily accessible to the operator.
Road Switch Assembly
FIGURE 9.
Insert the road switch (P/N 412-2011-104) into the road switch base (P/N 118-0159-056) and cover (P/N
1.
118-0159-057) housing.
Secure the housing with four #4-40 Phillips pan-head machine screws (P/N 311-0008-027).
2.
Route the ROAD SWITCH connector of the node harness (P/N 115-4001-161) to the chosen switch
3.
mounting location.
Connect the ROAD SWITCH connector to the road switch.
4.
Use one double-sided tape strip (P/N 332-0000-019) or two self-tapping screws (not provided) to mount the
5.
road switch to the selected mounting location.
Install the Valve Harness
Connect the round 19-pin connector of the valve harness (P/N 115-4001-162) into the port on the electrical
1.
access panel in which the node harness was installed.
Route the valve harness under the cab.
2.
Manual No. 016-5034-014 Rev. A
Cab Component Installation
13
Advertisement
Table of Contents
