Set Up Ipv4; Procedure; Step 1 - Cisco Unified IP Phone 8941 Administration Manual

Configure Network Settings
Option
PC Port Setup
LLDP-MED: Switch
Port

Procedure

Step 1

Press Applications.
Step 2 To access the Network Settings menu, select Administrator Settings > Network Settings.
Related Topics
Text Menu Entry from Phone, on page 31

Set Up IPv4

The following table describes the IPv4 Setup menu options.
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
34
Description
Speed and duplex of the access port. Valid
values:
• Auto Negotiate
• 1000 Full: 1000-BaseT/full duplex
• 100 Half: 100-BaseT/half duplex
• 100 Full: 100-BaseT/full duplex
• 10 Half: 10-BaseT/half duplex
• 10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure
both to autonegotiate.
If you change the setting of this option, you
must change the SW Port Configuration
option to the same setting.
Enables and disables Link Layer Discovery
Protocol Media Endpoint Discovery
(LLDP-MED) on the switch port. Use this
setting to force the phone to use a specific
discovery protocol, which should match the
protocol supported by the switch. Settings
include:
• Enabled (default)
• Disabled
To change
Set PC Port Setup Field, on page 37
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.