Cisco Unified Ip Phone Installation; Verify Network Setup - Cisco Unified IP Phone 8941 Administration Manual

Cisco Unified IP Phone Installation

•
•
•
•
•
•
•

Verify Network Setup

Before you install a phone, you must decide how to configure the phone in your network. Then you can install
the phone and verify its functionality.
For the phone to successfully operate as an endpoint in your network, your network must meet specific
requirements.
Note The phone displays the date and time from Cisco Unified Communications Manager. The time displayed
on the phone can differ from the Cisco Unified Communications Manager time by up to 10 seconds.
Procedure
Step 1 Configure a VoIP Network to meet the following requirements:
• VoIP is configured on your Cisco routers and gateways.
• Cisco Unified Communications Manager is installed in your network and is configured to handle call
Step 2 Set up the network to support one of the following:
Verify Network Setup, page 27
Enable Autoregistration for Phones, page 28
Install Cisco Unified IP Phone, page 29
Set Up Phone from Setup Menus, page 30
Configure Network Settings, page 32
Phone Startup Process, page 40
Configure Phone Services for Users, page 41
processing.
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
3
C H A P T E R
and SIP)
27