Cisco Unified IP Phone 8941 Administration Manual page 199

• 7 - Debugging
Contact Cisco TAC for more information and assistance.
Procedure
Step 1 In the Cisco Unified Communications Manager Administration, select one of the following windows:
• Device > Device settings > Common Phone Profile
• System > Enterprise Phone Configuration
• Device > Phone
Step 2 Set the following parameters:
• Log Profile - values: Preset (default), Default, Telephony
• Remote Log - values: Disable (default), Enable
• IPv6 Log Server or Log Server - IP address (IPv4 or IPv6 address)
Note When the Log Server cannot be reached, the phone stops sending debug messages.
• The format for the IPv4 Log Server address is address:<port>@@base=<0-7>;pfs=<0-1>
• The format for the IPv6 Log Server address is [address]:<port>@@base=<0-7>;pfs=<0-1>
• Where:
◦ the IPv4 address is separated with dot (.)
◦ the IPv6 address is separated with colon (:)
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
Troubleshooting Procedures
and SIP)
185