Set Tftp Server 2 Field; Set Secondary Load Server; Set Dhcp Address Released Field; Phone Startup Process - Cisco Unified IP Phone 8941 Administration Manual

Phone Startup Process

Set TFTP Server 2 Field

Procedure
Step 1
Unlock network configuration options.
Step 2 Enter an IP address for the TFTP Server 1 option.
Step 3 Scroll to the TFTP Server 2 option, press Select, and enter a new backup TFTP server IP address. If there is
no secondary TFTP Server, you can use Delete to clear the field of a previous value.
Step 4
Press Apply and then press Save.

Set Secondary Load Server

Procedure
Step 1
From Cisco Unified Communications Manager Administration, choose Device > Phone.
Step 2 Select Load server.
Step 3 Enter the server hostname or IP address.

Set DHCP Address Released Field

Procedure
Step 1 Scroll to the DHCP Address Released option and press Edit.
Step 2 Press Yes to release the DHCP Address.

Phone Startup Process

After the Cisco Unified IP Phone has power connected to it, the phone begins its startup diagnostic process
by cycling through the following steps.
1 The following LED buttons flash on and off during the various stages of bootup as the phone checks its
hardware. See the following table for a list of the hardware test and the LED diagnostic status.
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
40