Install Cisco Unified Ip Phone - Cisco Unified IP Phone 8941 Administration Manual

configuring autoregistration, see the documentation for your particular Cisco Unified Communications Manager
release.
Autoregistration must be enabled in Cisco Unified Communications Manager Administration for TAPS to
function.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, click System > Cisco Unified CM.
Step 2 Click Find and select the required server.
Step 3 In Auto-registration Information, configure these fields.
• Universal Device Template
• Universal Line Template
• Starting Directory Number
• Ending Directory Number
Step 4 Uncheck the Auto-registration Disabled on this Cisco Unified Communications Manager check box.
Step 5
Click Save.
Step 6 Click Apply Config.
Related Topics
Phone Addition Methods, on page 47

Install Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See
Connections, on page 18
page 19
Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before
Note
using external devices, read
To install a Cisco Unified IP Phone, perform the following tasks.
Procedure
Step 1 Choose the power source for the phone:
• Power over Ethernet (PoE)
• External power supply
See Phone Power Requirements, on page
for the connections for Cisco Unified IP Phone 8941 or
for the connections for Cisco Unified IP Phone 8945.
External Devices, on page 16
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
for safety and performance information.
6for guidelines.

Install Cisco Unified IP Phone

Phone
Phone Connections, on
and SIP)
29