Control Circuit Wire Gauges And Tightening Torques - YASKAWA GA800 600 V Drive Installation & Primary Operation

A - Terminal block (TB5)
B - Terminal block (TB2-3)
C - Terminal block (TB2-2)
D - Terminal block (TB2-1)
The tightening torque for the terminal screws is shown on the reverse side or the lower front side of the front cover.
Figure 10.2 Tightening Torque Display Location (Reverse side of Front Cover)
Figure 10.3 Tightening Torque Display Location (Lower Front Side of Front Cover)
■

Control Circuit Wire Gauges and Tightening Torques

Use the tables in this section to select the correct wires. Use shielded wire to wire the control circuit terminal block.
Use crimp ferrules on the wire ends to make the wiring procedure easier and more reliable.
YASKAWA TOEPC7106170VA GA800 600 V Drive Installation & Primary Operation
Figure 10.1 Control Circuit Terminal Arrangement
E - Terminal block (TB1)
F - Terminal block (TB3)
G - Terminal block (TB4)
10 Drive Start-Up Procedure
39