YASKAWA GA800 600 V Drive Installation & Primary Operation page 17

1.
Move the front cover to connect the hooks at the top of the front cover to the drive.
A - Hooks
2.
Move the front cover until it clicks into position while pushing on the hooks on the left and right sides of the
front cover.
Note:
Make sure that you do not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
3.
Reattach the keypad to the original position.
Remove the Terminal Cover
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION
the terminal cover can fall and cause moderate injury.
YASKAWA TOEPC7106170VA GA800 600 V Drive Installation & Primary Operation
Figure 6.7 Reattach the Front Cover
Figure 6.8 Reattach the Front Cover
Crush Hazard. Loosen the cover screws. Do not fully remove them. If you fully remove the cover screws,
Figure 6.9 Loosen the Terminal Cover Mounting Screws
6 Mechanical Installation
17