YASKAWA GA800 600 V Drive Installation & Primary Operation page 26

7 Electrical Installation
3.
Wire the closed-loop crimp terminal to the main circuit terminal block.
4.
Tighten the nut to the specified torque.
5.
Check the signal from the wired terminal and use a diagonal-cutting pliers to remove areas of the wiring cover
cutaway section.
Cut the areas shown in
A - Cutaway section
Note:
• Different drive models have different wiring covers.
• Remove only the areas from the wiring cover that apply to the wired terminal. If you remove areas that do not apply to the wired
terminal, the drive will not keep its IP20 protective level.
• Make sure that you hold the cutaway section tightly when you remove pieces of the cutaway section. Pieces of the cutaway
section can fly out and cause injury.
• Remove sharp edges from the wiring cover cutaway section to prevent damage to the wires.
• If you use the wiring cover correctly, but you use wires that are not specified by Yaskawa, the drive will not necessarily keep its
IP20 protective level.
26
Figure 7.5 Install the Electrical Wire
Figure 7.6 Tighten the Terminal Block Nut
Figure 7.7.
A
Figure 7.7 Clip the Cutaway Section of the Wiring Cover
YASKAWA TOEPC7106170VA GA800 600 V Drive Installation & Primary Operation
B
B
B - Use a diagonal-cutting pliers to clip this area.