Table of Contents
Advertisement
PRODUCT MARKING AND BARCODE IDENTIFICATION
t - Run Printer Self-test
cab printers have multiple built in self -tests. A self test can be processed through the printer´s control
panel (see operator´s manual) or by software.
The printout of the statusinformation may look different on different printer types. Information about
optional equipment, such as interfaces, cutter etc. will only be shown if they are attached.
The following syntax can be used for all printer types
Syntax:
t CR
The following syntax is available for A-Series and M-series printers only (Firmware
version 2.78 or higher)
Syntax:
t n CR
n = 0
n = 1
n = 2
t = 3
The status test is displayed in the selected language of the printer
t3
Example:
produces following result:
[TABLE OF CONTENTS] [COMMAND LIST]
64
- Prints status information
- prints the font list
- prints the device list
- prints the label profile
[ESC] [i] [L] [S]
cab Produkttechnik GmbH & Co KG
64
This
function is
available
for:
A-series
Apollo
Hermes
M-series
[INDEX]
Advertisement
Table of Contents
