Table of Contents
Advertisement
PRODUCT MARKING AND BARCODE IDENTIFICATION
X - Synchronous Peripheral Signal Settings
The X command can be used to control external devices.
Syntax:
X y[;ao] CR
Function and settings depend on the used printer type and the peripheral connector. Please refer to
the operator´s manual and to the documentation for the optional devices for each printer model.
The "X" command needs to be placed after the definition of the page size ! ("S"- command)
[TABLE OF CONTENTS] [COMMAND LIST]
168
X =
Synchronous Peripheral Signal Setting Command
y =
Printing coordinate when a signal should be set. Distance from print start
to start of the signal in millimeters or inches. (See the m command for the
measurement settings.
ao=
hex nibbles to set or to reset the signal
[ESC] [i] [L] [S]
cab Produkttechnik GmbH & Co KG
168
This
function is
available
for:
A-series
Apollo
Hermes
M-series
[INDEX]
Advertisement
Table of Contents
