Table of Contents
Advertisement
PRODUCT MARKING AND BARCODE IDENTIFICATION
O - Set Print Options
The O command is used to set a wide range of options which influences the complete label
Syntax:
O[M,][R,][N,][T,][S,][U,][p] CR
[TABLE OF CONTENTS] [COMMAND LIST]
158
O = Print Options command.
M=
Mirrored label printing
R =
Rotate the label contents 180 degrees
N =
Negative (inverted) printout of the complete label
S =
Single label buffer. The following label will be processed when the
actual one has finished printing.
T =
Enables the "tear off mode" which feeds the label more forward after
printing, so that it could be taken easier away.
U =
Suppresses the Pause / Reprint possibility to avoid that a label will be
printed twice.
p =
Printmode - backfeed option always / smart
backfeed "always" feeds the label back and starts printing at the label
margin, while "smart" suppresses the feedback.
"P" activates the smart option while "D" activates the "always" option.
This option overwrites temporarily the settings in the printer´s setup.
Using the "smart" mode has the benefit that the printer processes the
labels faster as the time is saved for pulling the labels back.
Nevertheless a negative effect may appear in the area where the
label is stopped under the printhead. This may cause a small
horizontal white line in the area. If this happens within an object, then
you must select the "D" option to avoid this effect.
[ESC] [i] [L] [S]
cab Produkttechnik GmbH & Co KG
158
This
function is
available
for:
A-series
Apollo
Hermes
M-series
[INDEX]
Advertisement
Table of Contents
