Media Sensor Calibration; Self Test - CAB e4 Series Operator's Manual

PRODUCT MARKING AND BARCODE IDENTIFICATION
The following parameters automatically reset:
- Label parameters
- Print darkness
- Speed
- Others for specific emulation
Note: The printed label count cannot be reset.

Media Sensor Calibration

It is necessary to perform Media Sensor Calibration after a new roll of
media is loaded.
1. After entering System Mode, press FEED button.
2. The three indicators continue blinking.
3. The printer will feed approximately 200mm, and then the three
indicators stop blinking and remain lit. The printer is back to a normal
state.

Self Test

1. After entering System Mode, press PAUSE button.
2. The three indicators continue blinking.
3. The printer will print out a configuration report and the three
indicators stop blinking and remain lit. The printer is back to a
normal state.
4. The following information will be printed on the report:
- Font list
- Hardware configuration and status
- DIP switch settings
- Label parameters
- Firmware version
22
cab Produkttechnik GmbH & Co KG
22