Installation; Unpacking The Label Printer; Setting Up The Label Printer - CAB a2+ Operating Instructions Manual

A2+/A4+/A6+/A8+

Installation

3 Installation
3.1

Unpacking the label printer

Lift the label printer out of the box via the straps.
Check label printer for damage which may have occurred during transport.
Check delivery for completeness.
Scope of delivery
•
Label printer
•
Empty cardboard core, mounted on ribbon take-up hub
•
Tear-off plate (basic devices only)
Retain the original packaging for subsequent transport.
3.2

Setting up the label printer

CAUTION!
The device and the print media can be damaged by moisture and water.
The label printer may only be set up in a dry place protected from sprayed water.
Fig. 1: Removing the transportation safeguards
Edition 5/06
1
2
Operating Instructions
•
Dispense plate (peel-off device ver-
sion only)
•
Power cable
•
Documentation
Set up printer on a level surface.
Open cover (1) of the label printer.
Remove foam transportation safeguards
near the printhead (2).
9