Connection Between The Housings - Honeywell ESSER IQ8Control C Installation Instruction

Fire Alarm Control Panel IQ8Control C / M
5.5

Connection between the housings

The compact housing is connected to the extension housing using the connecting pieces provided.
Fig. 20: Knockouts for battery cable
Damage to the system!
Take care to ensure that no cables are pinched or damaged.
The plastic connection brackets are not suited to carry the weight of the lower housing alone.
28
1
1
1
1. Remove the appropriate 2 plastic plates from
panels and extension housing
2. Push the plastic connector bracket in each
originated gap. Observe the arrows on the bracket
for the right direction.
3. Push the upper housing via the guide way of the
brackets towards the wall.
4. Align both connection brackets to ensure that the
cables between the housings may be lead
through the openings of the brackets.
5. Each housing must be fixed with suited screws
(4x) without twisting stress.
Example of housings
fitted vertically on top
of each other.
Always use two
connecting pieces 
with cable entries.
2 x connection pieces
with cable glands
FB 798951.10.GB0 / 04.15