Honeywell ESSER IQ8Control C Installation Instruction page 25

XX mm
Fig. 16: Fitting the panel to the mounting surface
FB 798951.10.GB0 / 04.15
4 x
Fire Alarm Control Panel IQ8Control C / M

Drill through the marks for the mounting holes to
create four holes and insert suitable anchors.

The type of anchor best suited to this purposes
depends on the mounting surface's material
(cavity wall, concrete, wood etc.) and must be
chosen accordingly.

The surface/wall and mounting material's load
bearing capacity must be adequate for bearing
the entire weight of the selected expansion model
(incl. batteries).

Please take note of the cable entry points before
fitting the housing!

Hold the housing against the mounting surface
and align.

Screw four screws into the screw anchors and
hand tighten.
25