Detector Replacement - Honeywell ESSER IQ8Control C Installation Instruction

Fire Alarm Control Panel IQ8Control C / M

10.3 Detector replacement

Replacement of fire and diagnostic detectors (4-zone module)
Diagnostic fire detectors can be replaced without adjustment of the detector address on the base circuit board or
overwriting data with the service PC. The menu options >Detector replacement< is inoperable for these detectors.
Replacement of intelligent detectors Series 9200 (loop)
Any number of detectors series 9200 / IQ8Quad or esserbus
replacement of detectors can be carried out in many cases without the service PC. (See table)
At the control panel
Using the table on next page,
find out whether the replacement can be carried out
without the service PC.
yes
Enter the installer code, select primary loop function,
enter the primary loop number and
select function 2 "swich off"
At the location
of the detector
Exchange all detectors which are to be replaced
in the loop. Screw the new detectors tightly into
the detector bases, do not damage connecting cables.
At the control panel
Enter the installation code, select primary loop
function, enter the primary loop number and select
function 4 "replace detector".
On the primary loop all zones and the Primary loop
are indicated on the display with "TEST"
Wait until the display "TEST"
for the primary loop go out.
Have malfunctions occurred?
no
Replacement of detectors is completed.
Fig. 87: Flow diagram of detector replacement
100
connect service-PC and
no
carry out automatic wiring
ring loop.
Which trouble code appears
yes
in the display ?
see section 11 (detector malfunctions).
Is this malfuntion
due to the replacement
of detectors?
yes
Switch the primary loop, detector
zone or detector. Replacement
of detectors is completed.
®
transponders in an loop can be replaced. The
Check the execution of the
no
replacement and reactivate
Replace detector function.
FB 798951.10.GB0 / 04.15