Simulation Of Control States - Honeywell ESSER IQ8Control C Installation Instruction

10.5 Simulation of control states

Under this menu point, the state of any control, such as relays or open collectors, can be simulated for test
purposes. The simulation of control states in an essernet
controls which are allocated to this Fire Alarm Control Panel and are programmed in the customer data with a
control zone number, such as:

Relay or open collectors of the micro modules of these FACP

Detector base outputs of fire detectors Series 9200 / IQ8Quad

Controls of esserbus
With the simulation of a control state, all programmed displays and controls for this control and state are activated
or deactivated. (Observe customer data programming).
Control simulation
:
Control
Status
Fig. 90: Entering the control number
Control simulation
: 15
Control
Status
Fig. 91: Selecting a function

Enter the control number of the corresponding open collector or relay

Press the Select function key

Enter the number for the desired function ( 1 = Activate, 2 = Trouble, 3 = End test) or select with the cursor
keys and press the function key >function< to acknowledge the input
To end this simulation, each individual control whose operating state has been simulated must be terminated with
the >End test< function!
For the master box controls (Control numbers 1 to 10), a simulation is impossible! Simulation of
individual detectors or zones is not supported via communications transponder (Part No. 808615) of
the 8010 extinguishing control system.
FB 798951.10.GB0 / 04.15
® transponders in the loop
Activation
Trouble
End test
Repeat
1 Activation
2 Trouble
3 End test
Fire Alarm Control Panel IQ8Control C / M
® is impossible. The function pertains exclusively to
*
By pressing the >Repeat< key,
the displayed control number is
incremented by the value "+1"
without the need of entering the
new (next higher) control number
Select on the keyboard.
Function
103