Honeywell ESSER IQ8Control C Installation Instruction page 73

®
7.1.6 essernet micro module (Part No. 784840 / 784840.10 and 784841 / 784841.10)
®
The essernet micro module must be placed on the micro module slot of the Basic module. There for it is required
to set the corresponding jumpers on the Basic module to configure the terminals for the essernet
 
essernet micro module 62,5 kBd (Part No. 784840)
 
essernet micro module 500 kBd (Part No. 784841)
Fig. 64: essernet ® micro module (Part No. 784840 / 784841)
or
 
essernet micro module 62,5 kBd (Part No. 784840.10)
 
essernet micro module 500 kBd (Part No. 784841.10)
essernet
X4 X5
®
Fig. 65: essernet micro module (Part No. 784840.10 / 784841.10)
System conformity according to EN 54-13 requires increased sensitivity in the monitoring of line
connections. This has been appropriately taken into consideration in the essernet
No. 784840.10 and 784841.10).
The software of the modules remains fully compatible with earlier versions.
If a new essernet
panel with an essernet
network, there may be - depending on the configurations of these line connections - an increase in
the number of fault messages.
Common reasons for such faults include corroded connection points and loose terminal connections
that were still within the tolerance ranges of the earlier versions of the essernet
If you encounter such fault messages, the entire line network must be carefully inspected.
Compliance with EN 54-13 requires that the greatest of care be taken when setting up such
networks, which have a significant impact on the manner of line installation and the connection
types.
FB 798951.10.GB0 / 04.15
S2 S1
X4 X5
X1
module
®
X1
®
module is installed into an existing system or if an additional fire alarm control
® module (Part No. 784840.10 or 784841.10) is integrated into an existing
Fire Alarm Control Panel IQ8Control C / M
essernet module
®
® micro module.
LED
red
yellow
green
LED
red
yellow
green
S2
S1
® modules (Part
®
modules.
73