Table of Contents
Advertisement
7
Completing installation
7.6
Installing a FBM/FBB bellows - optional
Fig.106
Fig.107
Fig.108
54
Bellows are mainly used as an additional form of protection for carriages against
dust and splashes of water.
1.
Prior to installing the bellows, ensure that guide rail fixing holes are sealed with
plugs and the cover strip.
2.
Slide the machine slide into approximately the centre of the stroke.
3.
Insert the adapter plate (2) in front of the first carriage (1). Ensure that the
countersink into the fixing hole is on the side facing away from the carriage.
4.
Secure the adapter plate to the middle lube connection thread of the front plate
using the central screw (3) (max. tightening torque 0.5 Nm).
5.
Mount the pre-assembled bellows (with supporting frame and rivets) onto the
guideway.
6.
Snap the rivets (4.7) at the end of the bellows into the corresponding holes in the
adapter plate.
7.
Insert the end plate (5) at the end of the guideway. Ensure that the side with
the countersink into the fixing holes is on the side facing away from the carriage.
8.
Secure the end plate using the screws included (6).
9.
Snap the rivets (4,7) at the end of the bellows into the corresponding holes (8)
in the adapter plate.
10. Check that the bellows slide well on the guideway and that the folds are not too
strongly compressed or stretched in the slide end positions.
Hide quick links:
Advertisement
Table of Contents
