Installing The Screw Cover; Mrk/Brk Plastic Plugs - Schneeberger MONORAIL Series Mounting Instructions

7
Completing installation
7.2 Installing the screw cover
Fig.52
Fig.53
CAUTION!
Risk of personal injury posed by sharp edges!
Could result in cutting injuries.
• Wear gloves.
• Protect wipers with an assembly protection strip when passing
the carriage over unsealed rail fixing holes.
The following screw covers are available:
• MRK plastic plugs for MR roller guideway
• BRK plastic plugs for BM ball guideway
• MRS brass plugs for MR roller guideway
• BRS brass plugs for BM ball guideway
• MRZ stainless steel plugs for MR roller guideway
7.2.1 MRK/BRK plastic plugs
This section describes the installation of MRK plastic plugs for the covering of rail
fixing holes in MONORAIL MR and BRK and MONORAIL BM guide rails.
Identification
The marking on the reverse side of the plastic plugs can be used to identify whether
they are MRK plastic plugs for MONORAIL MR (right in Fig. 52) or BRK plastic plugs
for MONORAIL BM (left in Fig. 52).
For plastic plug dimensions see „12 Appendix" on page 70.
Required tool
Carry out the installation using a plastic hammers and a spacer, e.g. a perspex block
or assembly rail.
Assembly process
1. Clean the rail fixing hole.
2. Place the plugs into the rail fixing holes. Ensure that the plugs are set parallel with
the rail surface.
3. Hammer the plugs in lightly.
4. Check that they are sitting properly.
5. Remove any swarf.
6. Hammer the plugs in until flush.
31