Schneeberger MONORAIL Series Mounting Instructions page 46

7
Completing installation
Fig.86
Fig.87
Recesses in
the groove
Fig.88
44
NOTE: Do not bend the free strip end at the end of the guide rail. Only move the
assembly tool up to the end of the guide rail. Do not move the pressure roller over the
end of the guide rail whilst applying pressure.
3. Turn the handle of the assembly tool in the direction of installation.
4. Slide the assembly tool back over the guide rail.
5. Press the strip into the groove along the full length of the guide rail.
Move the tool lengthwise whilst tilting it forwards.
Installation procedure for multi-part strips
General
Multi-part strips should only be used if e.g. multi-part guide rails have been laid
due to a long axis length and the installation situation requires it. A butt joint always
represents a potential problem spot for carriage wipers and should be avoided.
Minimum length
Minimum section length: 600 mm
Guide rail installation
Install multi-part guide rails for cover strips in accordance with „6.3 Handling guide
rails" on page 19. Install the rail segments so that at each butt joint the groove
for the cover strip is continued by the subsequent rail section (see figure).