Table of Contents
Advertisement
6
Installation
Fig.37
Fig.39
26
5.
Fasten one carriage on the pre-fastened guide rail to the mounting plate (3) with
screws.
6.
If carriages with additional wipers are protected by an installation protection film:
prevent the protective film from slipping (see „7.3 Removing the protective instal-
lation film for additional wipers (optional)" on page 48).
7.
Slide the mounting plate (3) with carriages back and forth. Tighten the fastening
screws of the unsecured guide rail tightly against the carriage (see „6.3 Handling
guide rails" on page 19).
8.
Fully fasten the mounting plate (3).
6.6.2 Installation option 2
Installation option 2 is applicable in cases in which locating surfaces are present for
both guide rails and for one carriage.
Fig.38
1.
Brace both guide rails (1), (2) against the locating surfaces and fasten with screws
(see „6.3 Handling guide rails" on page 19).
2.
Install clamping screws or clamping or wedge bars where required.
3.
Place the mounting plate (3) on the carriages and lightly tighten all fastening
screws.
4.
Brace the mounting plate (3) against the locating surfaces of the carriages
on the reference rail and fasten to both carriages.
5.
If carriages with additional wipers are protected by an installation protection film:
prevent the protective film from slipping (see „7.3 Removing the protective instal-
lation film for additional wipers (optional)" on page 48).
6.
Slide the mounting plate (3) with carriages once over the full length of the guide rails.
7.
Fully fasten the mounting plate (3).
Hide quick links:
Advertisement
Table of Contents
