Schneeberger MONORAIL Series Mounting Instructions page 29

6
Installation
Fig.41
Fig.42
6.6.3 Installation option 3
Installation option 3 is applicable in cases in which locating surfaces are present for
one guide rail and for both carriages.
Fig.40
1. Brace the reference rail (1) against the locating surface and fasten with screws
(see „6.3 Handling guide rails" on page 19).
2. Adjust the opposite guide rail (2) so that it is parallel and pre-fasten it.
3. Place the mounting plate (3) on the carriages and lightly tighten its fastening
screws.
4. Brace the mounting plate (3) against the locating surfaces of the carriages
on the rails on each side and fasten with screws.
5. If carriages with additional wipers are protected by an installation protection film:
prevent the protective film from slipping (see „7.3 Removing the protective instal-
lation film for additional wipers (optional)" on page 48).
6. Install clamping screws or clamping or wedge bars where required.
7. Slide the mounting plate (3) with carriages back and forth and tighten fastening
screws on the unsecured guide rail tightly against the carriage (see „6.3 Handling
guide rails" on page 19).
27