Handpiece Heater Burn In; Operation; Temperature Selection - Pace ST 65 Operation & Maintenance Manual

Set-Up/Operation

Handpiece Heater Burn In

Toeinsure optimum performance and long life, some new handpieces must undergo a
burn in procedure. A Red tag is attached to the handpiece and with replacement heater
assemblies. Follow the Burn In procedure listed on the tag when setting up a new ST 65
system or when replacing a handpiece heater assembly.
Ensure that the system is placed in a well-ventilated area. Smoke will be emitted from the
heater assembly during the burn in cycle.

Temperature Selection

Variable Temperature Control
Adjust the Variable Temperature Control Knob to the
desired temperature setting. Notice that the control dial
has a White graphic scale denoting temperature in °C
(Celsius) and a Yellow graphic scale denoting
temperature in °F (Fahrenheit). These numerical scales
denote the set tip temperature times 100 (e.g., "3" on the
White scale is 3 x 100 or 300°C).
Temperature/Dial Lock
The Variable Temperature Control Knob can be locked in
position to avoid accidental or unauthorized changes of
the temperature setting. Perform the following procedure
to lock the Variable Temperature Control Knob.
1. Adjust the Temp. Control Knob to the desired
temperature setting.
2. Using the Temp. Locking Key (hex key supplied
with system), tighten the set screw on the Temp.
Locking Ring closest to the front panel.
16
NOTE