Removing The Chuck; Raise Or Lower The Table; Tilt The Table - Craftex CS Series User Manual

Fig. 10
Remove the Chuck
1. Turn the feed handles to lower the
chuck to the lowest position.
2. Slide the wedge into the opening in the
quill and tap the wedge with a hammer
or mallet. The Chuck arbor will drop out
of the quill.
Protect the table with a piece of wood or
heavy carboard to prevent the chuck
from dropping onto the table.

RAISE OR LOWER THE TABLE

(Fig. 12 )
1. Loosen the support lock handle (1)
and turn the crank handle (2) until the
table is at the desired height.
2. Tighten the support lock handle
before drilling.
ROTATE THE TABLE (Fig. 12 )
1. Loosen the support lock handle (1)
and turn the table around the column to
the desired position.
Note: The rack should rotate around the
column with the table support bracket. If
the rack binds and does not rotate,
slightly loosen the set screw in the rack
collar.
2. Tighten the support lock before
drilling.
Fig. 12
TILT THE TABLE (Fig. 12)
1. Rotate the table clockwise with the fork
wrench. Pull out the location pin. Put the
location pin and nut in suitable area.
2. Rotate the bolt (1) counter-clockwise
with a wrench to loosen it.
3. Adjust the angle of the table.
4. Tighten the bolt with fork wrench.
13