Installing The Table; Installing The Backstop - Craftex CT180 User Manual

INSTALLING THE TABLE

The table is most commonly installed to be
used with the sanding disc but it can also
be installed to be used with the sanding belt
when the sanding belt is in vertical position.
Loosen the two cap screws shown in figure-
9 and slide the table support rod into the
hole, making sure that the flat surface of the
rod is facing the two cap screws. Then
tighten the two set screws.
Slide the table with its bracket onto the
support rod as shown in figure-9, making
sure that the flat surface of the rod is facing
the cap screws on the table bracket, and
then tighten the cap screws. See figure-9.
Figure-9 Table to be used with the sanding
disc
Figure-10 Table to be used with the
sanding belt
INSTALLING THE
BACKSTOP
When the sanding belt is set for horizontal
sanding, the backstop should be used to
prevent the work piece flying out while
sanding.
Install the backstop to the sanding platen as
shown in figure-11 using screw and washer
provided.
Figure-11 Installing the backstop
IMPORTANT
Make sure to remove the backstop when
using the work table with the sanding
belt in vertical position.
11