Outfeed Table Adjustment - Craftex CX12HC User Manual

Figure-14 Infeed table positive stop bolts
Retighten locknuts.
We recommend that the height of the infeed
table to be adjusted so that the table at its
highest point will be 1/2mm below the
highest point of the cutter inserts. This is an
important feature of your jointer which
enables you to rapidly position the infeed
table for a finish or final cut.
OUTFEED TABLE
ADJUSTMENT
For most jointing operations the outfeed
table must be exactly level with the cutter
inserts at their highest point of revolution.
To move the outfeed table, loosen lock
lever shown in figure figure-15 and move
the table height lever up or down until the
table is level with the cutter inserts.
Figure-15 Outfeed table height adjustment
It may be necessary to adjust the positive
stops. Loosen the two locknuts shown in
figure-16 when moving the table up or
down.
Figure-16 Outfeed table positive stops
Turn the bolts and when the table is exactly
level with the cutter inserts at the highest
point of revolution, retighten the lock nuts.
13