FIGURE 8. Node Harness Connected to Power Leads
Switched
Power
Ground
9. Connect the power leads to the battery studs located behind the operator's seat.
INSTALL THE VALVE HARNESS
1. Connect the VALVE connector of the valve harness cable (P/N 115-4001-111) to the PVE port of the SmarTrax
valve (P/N 334-0003-088).
FIGURE 9. Valve Harness Connected to Flow Switch
2. Plug the PS1 and PS2 connectors from the valve cable into the pressure transducers on the flow switch (P/N
334-0003-085).
NOTE:
These connections can be plugged into either transducer.
Manual No. 016-5032-037 Rev. A
CAB COMPONENT INSTALLATION
Power
27