Install The Foot Switch; Install The Valve Harness - Raven SmarTrax Installation Manual

Chapter 5

Install the Foot Switch

Foot Switch Installed
FIGURE 6.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Locate the ENABLE connector on the node harness and connect it to the foot switch cable connector.
4.

Install the Valve Harness

Note:
MFWD models will use valve harness (P/N 115-4001-136). 2WD models will use valve harness
(P/N 115-4001-137). Steps 1-4 apply for both harnesses.
Connect the 12-pin connector of the valve harness (P/N 115-4001-136 or 115-4001-137) into the mating
1.
connector of the node harness (P/N 115-4001-109). Route the remainder of the harness underneath the
cab and toward the SmarTrax valve.
Pressure Transducer Connection
FIGURE 7.
32
Case IH Puma 115-160/New Holland Non-Delta Series T60x0 SmarTrax™ Installation Manual