Install The Was - Raven SmarTrax Installation Manual
Agco dt-a series, massey ferguson 84x0 series, challenger mt6x5b series
Hide thumbs
Also See for SmarTrax:
- Calibration and operation manual (156 pages) ,
- Operation manual (73 pages) ,
- Installation manual (59 pages)
Table of Contents
Advertisement
INSTALL THE WAS
FIGURE 5. Machine's Axle Housing Bolts
1. Remove the machine's two axle housing bolts shown in the figure above.
FIGURE 6. Machine's Axle Housing Bolts Installed on WAS Bracket
2. Install the machine's axle housing bolts on the WAS bracket (P/N 107-0172-106).
3. Install two 5/8" split lock washers (P/N 313-1000-045) over the end of the installed axle housing bolts.
Wheel Angle Sensor (WAS) Installation: Install the WAS
WHEEL ANGLE SENSOR (WAS) INSTALLATION
27
Advertisement
Table of Contents
