Node Mounting Locations; Install The Foot Switch - Raven SmarTrax Installation Manual

Agco dt-a series, massey ferguson 84x0 series, challenger mt6x5b series

Hide thumbs Also See for SmarTrax:

Table of Contents

NODE MOUNTING LOCATIONS

FIGURE 4. Node Mounting

When choosing the location for the SmarTrax node, consider the following points:

• Mount the SmarTrax node inside the machine's cab on a flat, level surface for proper performance and cable

connection.

• One of the six numbered direction arrows on the node must be oriented in the direction of forward vehicle

travel, one arrow pointing straight up, and two of the arrows parallel to the ground.

NOTE:

Make a note of the number of the arrow that is oriented in the direction of forward vehicle travel. This

number will be needed during the SmarTrax calibration process.

• The node mounting location must not create tripping hazards.

• Mount the node in a location where it will not be kicked or jarred during normal equipment operation.

• The location must allow cable routing to avoid crimping or damaging the cables or the node connections.

• Securely fasten the node using bolts or screws through at least two of the three mounting holes. When

mounted properly, the node should not become loose or rotate.

FIGURE 5. Foot Switch Installed

Cab Component Installation: Install the Foot Switch

Direction Arrows

Any two arrows

must be parallel

with level ground

Mounting

Tabs

CAB COMPONENT INSTALLATION

Table of Contents