FIGURE 9. Stud End of WAS Linkage Rod Installed
11. Insert the stud mount end of the WAS linkage rod assembly into the hole in the WAS rotary arm bracket
(P/N 116-0159-721) and secure it with one M10 nyloc insert lock nut (P/N 312-4000-208).
12. Ensure the machine's wheels are pointing straight forward, then slide the installed muffler clamp along the tie
rod until the WAS rotary arm bracket is pointing straight up and down as shown in the figure above.
13. Tighten the nuts on the muffler clamp evenly to secure the WAS linkage rod assembly in place.
14. Tighten the M10 jam nuts on the tie rod assembly so that each end can swivel an equal amount.
Wheel Angle Sensor (WAS) Installation: Install the WAS
WHEEL ANGLE SENSOR (WAS) INSTALLATION
29