C
4
HAPTER
FIGURE 7. WAS Installed on Machine's Axle
4. Install the WAS assembly on the axle housing as shown in the figure above.
NOTE:
Use thread locking compound on the bolts and adequately tighten.
5. Secure the WAS cable away from moving parts, using plastic cable ties as necessary.
FIGURE 8. Ball End of WAS Linkage Rod Installed
6. Remove the nuts and clamp from the U-bolt muffler clamp (P/N 435-3003-053) and install the U-bolt around
the right tie rod.
NOTE:
Discard the nuts from the muffler clamp. They are not used in the system installation.
7. Install the clamp on the ends of the U-bolt.
8. Install one 3/8"-16 nylon insert lock nut (P/N 312-4000-061) on the top leg of the U-bolt as shown in the figure
above.
NOTE:
Do not fully tighten the nut.
9. Install the ball end of the WAS linkage rod assembly on the bottom leg of the U-bolt.
10. Secure the WAS linkage rod assembly to the U-bolt using one 3/8"-16 nylon insert lock nut (P/N 312-4000-061)
and 3/8" steel flat washers (P/N 313-2300-013) as needed.
NOTE:
Do not fully tighten the nut.
28AGCO DT-A Series, Massey Ferguson 84x0 Series, Challenger MT6x5B Series SmarTrax Installation Manual