Remove all supplemental support bearings from the right side of the planter row units, opposite the seed
2.
meter drive sprocket.
Note:
Supplemental support bearings are generally located next to folding or flex points, or where drive
chains from the transmission attach to the main hex shaft.
Components to be Removed as Needed
FIGURE 4.
Remaining jack shafts, transmissions, and/or OEM hydraulic motors can be removed as needed if they
3.
interfere with the OmniRow installation.
Install the OmniRow Hydraulic Motors
Manual No. 016-3001-004
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic
fluid within the machine's system may be
extremely hot and under high pressure.
Hydraulics
7