Raven SmarTrax Installation Manual page 30

Agco dt-a series, massey ferguson 84x0 series, challenger mt6x5b series

Hide thumbs Also See for SmarTrax:

Table of Contents

HAPTER

FIGURE 3. Arm Bracket Installed

3. Mount the arm bracket (P/N 116-0159-721) on the WAS shaft by installing the 1/4"-20 knurled cup hex socket

head set screw (P/N 311-0015-729) through the hole in the arm bracket and tighten against the flat spot on the

sensor shaft.

FIGURE 4. WAS Linkage Rod Assembly

4. Install the M10 jam nut (P/N 312-1001-035) and M10 stud linear sensor mount (P/N 103-0001-030) on one end

of the WAS linkage rod (P/N 107-0172-125).

NOTE:

Do not fully tighten the nut.

5. Install the other M10 jam nut and the M10 ball linear sensor mount (P/N 103-0001-029) on the other end of the

WAS linkage rod.

NOTE:

Do not fully tighten the nut.

26AGCO DT-A Series, Massey Ferguson 84x0 Series, Challenger MT6x5B Series SmarTrax Installation Manual

Table of Contents