Table of Contents
Advertisement
Baker AWA-IV Software Overview
Step Voltage Test
The Step Voltage test, also called a step test, is described in detail in IEEE 95. Clicking on the drop-down arrow for
HiPot tests reveals the Step Voltage test. Clicking on the Step Voltage test menu item will start the Configuration
Wizard used to set up the test.
Fill in the appropriate information for the steps needed. Make sure the steps are appropriate for the application
being tested.
The second window is used to enter up to 30 voltage steps or test intervals for each step. This window will also
appear when the Step Voltage test runs and will display a real-time graph of the voltage and current collected during
the test. After this test has been set up, it can be edited prior to running. Click on Config in the DC Tests setup
window and the second step page appears.
64
Baker AWA-IV 71-015 EN V16 User Guide
Fig 66: Step voltage Config Wizard—step 1.
Fig 67: Step voltage Config Wizard—step 2.
www.megger.com
Advertisement
Table of Contents
