Transferring Test Ids - Megger Baker AWA-IV User Manual

Database Management and Maintenance

Transferring Test IDs

Test IDs can be transferred separately from Motor IDs.
1. To transfer Test IDs, you will follow essentially the same process described in the "Transferring motor and test
result data" section above. The source and destination databases must be open before a transfer can be
performed. When both databases are open, the Transfer Test IDs button will be enabled. Click on this button
to open the Transfer Test IDs window.
2. The window displays all Test IDs in the source database, along with the Test IDs currently found in the destination
database. Choose the source Test IDs to transfer by highlighting them. To select multiple IDs, use the Shift and
Ctrl keys on your keyboard while clicking on the Test IDs.
3. With the desired Test IDs highlighted, click on the Transfer button to start the transfer.
4. The software will transfer (copy) the requested Test IDs to the destination database. If a Test ID exists in the
destination database, it will overwritten with the parameters assigned to the selected TestID.
5. As in the motor and test result record transfer, the application writes to the Transfer Log, recording what action
has been taken. When finished transferring Test IDs, click on the Close button to return to the Data Transfer
window.
20 Baker AWA-IV 71-015 EN V16 User Guide
Fig 16: Transfer test IDs.
www.megger.com