Test Id Table-(Testid) - Megger Baker AWA-IV User Manual

Test ID Table—(TestId)
The TestId table contains information that is used to set up the test criteria. There is only one motor record per
motor. The test_key is the primary key. It is automatically generated when a new test is added. The testid field is
a unique identifier that the user gives each set of test criteria to identify what motor(s) is meant to be tested. For
example, 480 V w/o PI.
Table 45: Test ID table field descriptions.
Field name
test_key
testId
datetime_modified
temp_enabled
resist_enabled
Meg-Ohm_enabled
pi_enabled
HiPot_enabled
PrgHiPot_enabled
Surge_enabled
Table 46: Test ID table; temperature test parameters field descriptions.
Field name
temp_isAuto
temp_degF_C
Table 47: Test ID table; resistance test parameters field descriptions.
Field name
resist_no_leads
resist_deltaR_enabled
resist_ deltaR_maxpercent
resist_external_enabled
resist_isAuto
resist_4lead_test_enabled
resist_correct_to_temp_
enabled
resist_temp_correct_to
resist_temp_correct_factor Double
resist_target_coilRes_
enabled
resist_target_coilRes
resist_target_coilRes_
tolerance
162 Baker AWA-IV 71-015 EN V16 User Guide
Type Description
Long integer Automatically generated number used as the primary key.
Text (25) Test identification.
Date/Time Date and time stamp as to when a Test ID gets updated.
Yes/No Temperature test: 1=on; 0=off.
Yes/No Resistance test: 1= on; 0=off.
Yes/No Meg-Ohm test: 1=on; 0=off.
Yes/No PI test: 1=on; 0=off.
Yes/No HiPot test: 1=on; 0=off.
Yes/No Step Voltage Test enabled: 1=on; 0=off.
Yes/No Surge test: 1=on; 0=off.
Type Description
Yes/No 1=Manual; 0=Automatic.
Yes/No 1=F degrees; 0=C degrees.
Type Description
Short integer # of leads (2 or 3) Used also in surge.
Yes/No 1=delta R used in pass/fail; 0=Not used.
Short integer Max difference in percent.
Yes/No Always false 0=No external testing.
Yes/No 1=Automatic; 0=Manual
Yes/No 1=4 lead test enabled; 0=4 lead test disabled (Only disabled at
this time)
Yes/No Correct resistance 1=Yes; 0=No.
Short integer Defines the value that the resistance temperature will be
corrected to.
Default 234.5 for copper.
Yes/No 1=Coil resistance checking enabled; 0=not enabled.
Double Coil resistance to compare tested value with.
Long integer Tolerance set for target coil resistance.
www.megger.com