Table of Contents
Advertisement
7. Enter a value for the Surge Voltage based on your company and/or standards body recommendations for the
motor armature being tested. For this example, we use 600 volts.
8. Check the P-P EAR box.
9. Ensure that the Enable PP box is not checked.
10. Check the ARM box as shown in the example below.
11. Immediately after you check the Arm box, the Surge Test setup window will change to the Surge Test Armature
setup window as shown in the example below.
NOTE: If the ARM check box is not visible, the Baker AWA-IV being used is not configured to work with a Baker ZTX.
www.megger.com
Using the Baker AT101 ZTX with Baker AWA-IV Analyzers
Fig 133: Enable Baker ZTX by checking Arm box.
123
Advertisement
Table of Contents
