Test Procedures
Review the PI test results by pressing the PI tab. PI view will display the PI/DA graph along with a table of the current
and Megohm readings gathered at specific times. The PI voltage, DA ratio, and PI ratio are displayed on the right
side. Because this test was a DA, only the PI ratio has I=0 No PI indicating there is no PI value because the current
was zero.
Fig 109: Reviewing PI test data.
Click on the Surge tab to view surge test data.
Fig 110: Surge waveform view.
100
Baker AWA-IV 71-015 EN V16 User Guide
www.megger.com