Creating A New Motor Voltage Class - Megger Baker AWA-IV User Manual

Test Procedures

Creating a New Motor Voltage Class

If an appropriate motor class is not available for your specific motor, you can create a new one following this
procedure.
1. Open the Tests tab.
2. Check the Edit Test ID box and enter password as needed.
3. Click the Add button.
4. Click the Add Blank Test ID radio button to enable the fields below.
5. In the Target Motor Voltage Class field, enter the value for the new motor class needed. In the following
example, we created a 230 Volt class.
6. You do not need to enter anything in the Enter new Test ID field, but you can do so if you plan to create a new
Test ID as well.
Fig 127: Creating a new motor voltage class via the Create New Test ID dialog.
7. Click on the Add Voltage Class button then click Yes in the confirmation dialog that appears next.
The new motor voltage class will be added to the list for future use.
116 Baker AWA-IV 71-015 EN V16 User Guide www.megger.com