Megger Baker AWA-IV User Manual page 118

Test Procedures
4. Press the L2 button on the AWA front panel. The Zero-start Override feature will immediately apply the target
voltage level. Inspect the waveform and L-L EAR values, and complete the testing process as described above.
WARNING: When using the Zero-start Override feature, target voltage levels will be immediately applied
to the device when the L2 button is pressed. Ensure that no one contacts the device or tester leads to
avoid injury.
Additionally, when using this feature, do not move the Voltage Output Control knob. Changing the knob
position will result in an improper test voltage level, which could damage the device under test.
106 Baker AWA-IV 71-015 EN V16 User Guide www.megger.com